| It is currently Fri Mar 07, 2014 11:23 am |
|
All times are UTC - 6 hours [ DST ] |
 |
Page 1 of 1 |
[ 2 posts ] |
| Print view | Previous topic | Next topic |
| Author | Message |
|---|---|
 Joined: Sun Nov 09, 2008 2:49 pm Posts: 555 |
 Clip-on Heat Sink vs. Bolt-on Cooling FinErrata for Fatman Manual
Page 2 First paragraph, last sentence should read “Check the parts supplied against the packing list on page 3 of this manual”. Page 3 Packing List Voltage Regulator Cooling Fin is now Heatsink, TO220 – clip-on style Page 10 Voltage Regulators Install clip-on style heatsink on IC19 (7805) before installing on printed circuit board. Page 15 Socket Mounted ICs Disregard the statement to “attach the aluminum radiator fin … in the illustration” and the illustration to the right. The heatsink for this part is now a clip-on style and was installed on the regulator back on page 10 when you were installing all the regulators. _________________ Scott Lee scott@paia.com |
| Mon Jan 31, 2011 2:32 pm |
 |
 |
|
|
Joined: Sun Nov 09, 2008 2:49 pm Posts: 555 |
Re: Clip-on Heat Sink vs. Bolt-on Cooling Fin It is also best to install the combined resistors, R117, so there isn't so much exposed wire that could touch the clip-on heat sink.
Below is a pdf detailing this and the installation of the clip-on heat sink. Note, there was also an earlier change omitting the fin/heatsink from the IC20 voltage regulator. Attachment: _________________ Scott Lee scott@paia.com |
| Tue Aug 09, 2011 12:28 pm |
|
|
|
|
|
Page 1 of 1 |
[ 2 posts ] |
|
All times are UTC - 6 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 1 guest |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |