PaiaTalk
http://www.paia.com/talk/

TubeHead, trouble-shooting tips and suggestions
http://www.paia.com/talk/viewtopic.php?f=29&t=224
Page 1 of 1

Author:  PAiA-Scott [ Thu Jul 01, 2010 9:52 am ]
Post subject:  TubeHead, trouble-shooting tips and suggestions

TubeHead trouble-shooting tips and suggestions

Attachment:
9305ts.pdf [38.84 KiB]
Downloaded 2205 times


'TubeHead Quality' topic

http://www.paia.com/talk/viewtopic.php?f=4&t=29&start=0

'Bass/Guitar (and other instruments) and TubeHead' topic

http://www.paia.com/talk/viewtopic.php?f=4&t=80&start=0

The shielded cable wiring can be substituted with gently twisted pairs of #26 insulated wire (tube socket to board wiring too). With the lengths determined for runs in a group with the board upside down and to the side, it is much easier to access the bottom of the board for touching-up soldering or replacing parts. A single length of #22 insulated wire makes the run from SG to the panel ground points.

Image

Larger Image

Image

Larger Image

TubeHead Printed-Circuit-Board Soldering Example

Board Soldering Example

To get the rolled aluminum spacers to hold the machine screws to the case-bottom as can be seen in the images above, reference this note:

https://paia.com/talk/viewtopic.php?f=4&t=22&start=0

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/
Not able to open ./cache/data_global.php