PaiaTalk
http://www.paia.com/talk/

Soldering Help...
http://www.paia.com/talk/viewtopic.php?f=8&t=534
Page 1 of 1

Author:  warpandwoof [ Wed Aug 28, 2013 6:29 pm ]
Post subject:  Soldering Help...

It's been a while since I've done some soldering, and I'm using a different iron, and I did some not-so-pretty work on the first round of resistors (only realized it when I flipped the board over - looked great from the bottom).

I *know* this is a stupid question, but indulge me: if I meter the resistor from one lead to an open hole that is connected through the board back to the other lead, and it meters correctly and consistently, is this evidence of a solid connection regardless of somewhat boogered-up-ness?

Thanks people!

Author:  PAiA-Scott [ Thu Aug 29, 2013 9:27 am ]
Post subject:  Re: Soldering Help...

Yes, there is likely a solid connection, but be careful about continuing to feed solder to the heated joint as it will flow through the hole and accumulate on the top side of the board.

http://paia.com/manuals/docs/KitAssemblyTips.pdf

http://paia.com/manuals/docs/KitSolderingItems.pdf

Author:  warpandwoof [ Thu Aug 29, 2013 10:47 am ]
Post subject:  Re: Soldering Help...

Thanks! Yeah, I had to use my solder sucker to suck away the solder there because of my sucky soldering technique. :)

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/
Not able to open ./cache/data_global.php