PaiaTalk
http://www.paia.com/talk/

frac cabinets
http://www.paia.com/talk/viewtopic.php?f=8&t=567
Page 1 of 1

Author:  Billb3 [ Sun Jan 12, 2014 6:30 pm ]
Post subject:  frac cabinets

I need a cabinet of sorts to put my 2720/4700 modules in.

are there blueprints for the wing cabinets? (although I suppose it wouldnt be that hard to figure out a reasonable config).

curious as to what others have done when they had to home brew cabinets.

bill

Author:  toneman [ Sun Jan 12, 2014 7:51 pm ]
Post subject:  Re: frac cabinets

Easiest boxes are like PAiA used to build: particleboard. Use 1/2in particle board that is rabbited on the edges. Then use 1/4 x 1/4 aluminum angle from home depot for mounting panels. drill new holes as U need them. Make an easilly removable back (or top) for hooking up the power supply. 8-)

Author:  Billb3 [ Sat Jan 18, 2014 7:41 pm ]
Post subject:  Re: frac cabinets

I hacked out a wing cabinet. not very pretty at this point.
I need to add the metal bars to hold the modules in place.

http://www.flickr.com/photos/29708075@N08/12021077084/
http://www.flickr.com/photos/29708075@N08/12020725595/
http://www.flickr.com/photos/29708075@N08/12021558526/

here is my rackmount version - I call it EuroFrac.

http://www.flickr.com/photos/29708075@N08/12021557136/
http://www.flickr.com/photos/29708075@N08/12020722125/
http://www.flickr.com/photos/29708075@N08/12021009523/

bill

Author:  toneman [ Sat Jan 18, 2014 11:17 pm ]
Post subject:  Re: frac cabinets

That aluminum fracrack looks great!

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/
Not able to open ./cache/data_global.php