The page linked below details the settings for MIDI Channel on FatMan. Before August 14, 2014, the charts for this were not correct. The first manuals were OK for 1 and 16, and then a "corrected" version had some, but not all correct. This must have been due to making the corrections one at a time and sometimes reverting to the board mis-labeling of bit-significance ordering. Thanks Jim W. for bringing this to my attention.
An image of the eight-sectioned DIP Switch on a desktop version of FatMan is shown to clarify that the installation of this part is with section one towards the rear edge of the board (same as it is when on the top side for the rack version). A sticker or marking covering the MSB (section 1, nearest the rear edge) through LSB (section 4,farthest from the rear edge). Only the first four sections are relevant and the settings of the fifth through the eighth have no bearing.
9308 FatMan, MIDI Channel DIP Switch Settings
http://www.paia.com/manuals/docs/9308_M ... _81414.pdf
Technical notes, diagrams and schematics for the FatMan series of PAiA products.
1 post • Page 1 of 1