|9770 series power supplies, 9790 power connector kit, FR-7
|Page 1 of 1|
|Author:||PAiA-Scott [ Mon May 03, 2010 1:38 pm ]|
|Post subject:||9770 series power supplies, 9790 power connector kit, FR-7|
Download or view the following pdf for details about the 9770 series power supply, the four-wire power supply connector cables, and the FR-7 Fractional Rack-mount chassis.
It contains information for the Mouser part numbers and the references for building the cables from the 9710 manual.
When soldering the tinned wire ends to the terminal, I use a wooden clothes pin to hold the terminal steady. I flow a tiny bit of solder into the area where the wire end will rest and then position the wire end there and reheat, flowing in a tiny bit more solder. Note if the terminal is slightly angled down during this process, the solder will be less likely to run up to the sprung, contact end of the terminal.
9770_9790_FR7.pdf [385.62 KiB]
Downloaded 2729 times
|Page 1 of 1||All times are UTC - 6 hours [ DST ]|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group