It is currently Thu Jul 02, 2020 6:46 pm

Post new topic Reply to topic  [ 3 posts ] 
 2720-5 LFO and noise levels 
Author Message

Joined: Wed Jan 06, 2010 1:33 pm
Posts: 3
Post 2720-5 LFO and noise levels
I'm currently rebuilding an old Paia modular with a mixture of 4700 and 2700 modules and i'm having a bit of difficulty with the pair of 2720-5 control oscillator modules.

The LFO output on both were a little hit and miss until i replaced the 2N2712 in the LFO section of each with a 2SC945 and the 2N3391 in one of them with a BC548, accounting for the different pin out.
Now they both speed up and slow down okay, and the switching is working properly, but the peak to peak voltage changes from about 5v at the slowest speed to more like 7.5v at higher speeds. They both do the same thing even when i swapped out the transistors for originals from other modules so i'm assuming that this is normal?

The other issue is the noise sources. One of the modules wasn't outputting any noise and the other was working but the noise seems to be about 5v peak to peak. In the build guide it seems to say that the noise should be both 5v and 0.5v peak to peak at different points in the setup and testing section. I've tried swapping the noise transistor at Q3 in both modules, which got the dead one working again, but the noise level seems to vary wildly using different 2712 transistors let alone replacing it with a 2SC945. I've had anything from 0.5v to 8v peak to peak using different 2712's!

What kind of level should i actually be seeing at the noise output jack?
I'm assuming this must have something to do with the noise transistor gain, if so is there an ideal value?

Mon Jul 02, 2012 7:47 am
User avatar

Joined: Sun Nov 09, 2008 2:49 pm
Posts: 733
Post Re: 2720-5 LFO and noise levels
The noise is usually about 0.5v and the control oscillator about 5v.

We used to grade the transistors supplied for the noise source. Some are hot, some are not, some are just right. They shouldn't have ticks and clicks in the sound.

It is normal the control oscillator amplitude changes some with frequency.

Scott Lee

Thu Jul 05, 2012 3:04 pm

Joined: Wed Jan 06, 2010 1:33 pm
Posts: 3
Post Re: 2720-5 LFO and noise levels
Many thanks for your reply.

I had assumed that the noise output should be about 0.5v to match the VCO output, but the variation in levels you get when changing noise transistor seems to be way bigger than i would expect.

Is it normal to see such a massive difference in output levels just from changing the noise transistor? A difference of 0.5v to 7-8v peak to peak, and anywhere in between, seems a bit excessive.

I guess if it is actually working properly its just going to be a case of trial and error to find a usable noise source.

Tue Jul 10, 2012 6:09 am
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

Who is online

Users browsing this forum: No registered users and 6 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © phpBB Group.
Theme designed by Vjacheslav Trushkin , adapted for PAIA by Illumimedia Design Studios
./cache/ is NOT writable.