I need a cabinet of sorts to put my 2720/4700 modules in.
are there blueprints for the wing cabinets? (although I suppose it wouldnt be that hard to figure out a reasonable config).
curious as to what others have done when they had to home brew cabinets.
bill
frac cabinets
-
- Posts: 99
- Joined: Thu Sep 24, 2009 2:14 pm
- Hometown: sacto texas
- Favorite topic: electric vehicles
- Super Robot Smashing Puzzle Time!: 12
Re: frac cabinets
Easiest boxes are like PAiA used to build: particleboard. Use 1/2in particle board that is rabbited on the edges. Then use 1/4 x 1/4 aluminum angle from home depot for mounting panels. drill new holes as U need them. Make an easilly removable back (or top) for hooking up the power supply. 

IF U THINK U GOT A GOOD DEAL....U DID!!
-
- Posts: 61
- Joined: Wed Jan 01, 2014 1:36 pm
- Hometown: Toronto
- Favorite topic: custom mods
- Super Robot Smashing Puzzle Time!: 12
- Location: Toronto
Re: frac cabinets
I hacked out a wing cabinet. not very pretty at this point.
I need to add the metal bars to hold the modules in place.
http://www.flickr.com/photos/29708075@N08/12021077084/
http://www.flickr.com/photos/29708075@N08/12020725595/
http://www.flickr.com/photos/29708075@N08/12021558526/
here is my rackmount version - I call it EuroFrac.
http://www.flickr.com/photos/29708075@N08/12021557136/
http://www.flickr.com/photos/29708075@N08/12020722125/
http://www.flickr.com/photos/29708075@N08/12021009523/
bill
I need to add the metal bars to hold the modules in place.
http://www.flickr.com/photos/29708075@N08/12021077084/
http://www.flickr.com/photos/29708075@N08/12020725595/
http://www.flickr.com/photos/29708075@N08/12021558526/
here is my rackmount version - I call it EuroFrac.
http://www.flickr.com/photos/29708075@N08/12021557136/
http://www.flickr.com/photos/29708075@N08/12020722125/
http://www.flickr.com/photos/29708075@N08/12021009523/
bill