PaiaTalk

I need a cabinet of sorts to put my 2720/4700 modules in.

are there blueprints for the wing cabinets? (although I suppose it wouldnt be that hard to figure out a reasonable config).

curious as to what others have done when they had to home brew cabinets.

bill

Easiest boxes are like PAiA used to build: particleboard. Use 1/2in particle board that is rabbited on the edges. Then use 1/4 x 1/4 aluminum angle from home depot for mounting panels. drill new holes as U need them. Make an easilly removable back (or top) for hooking up the power supply.

I hacked out a wing cabinet. not very pretty at this point.
I need to add the metal bars to hold the modules in place.

http://www.flickr.com/photos/29708075@N08/12021077084/
http://www.flickr.com/photos/29708075@N08/12020725595/
http://www.flickr.com/photos/29708075@N08/12021558526/

here is my rackmount version - I call it EuroFrac.

http://www.flickr.com/photos/29708075@N08/12021557136/
http://www.flickr.com/photos/29708075@N08/12020722125/
http://www.flickr.com/photos/29708075@N08/12021009523/

bill

That aluminum fracrack looks great!