Looking For Enclosure Suggestions for Back of Rack

Free-for-all discussion about PAiA products and the kinds of audio you produce with them.
Post Reply
buck1107
Posts: 28
Joined: Wed Sep 05, 2012 10:54 am
Hometown: Little Baisley By the Sea
Favorite topic: Emma Peel
Super Robot Smashing Puzzle Time!: 12

Looking For Enclosure Suggestions for Back of Rack

Post by buck1107 »

I was wondering if there is a good, ready made, 'back enclosure' to hold and protect the circuit board, pots, jacks on the backside of a rack unit?
Years ago, I shaped a sort of 'tray' out of metal, which worked ok, for my Paia Parametric Eq; however, I have seen some built Paia kits that have an enclosed aluminum box attached to the back of the rack panel. Additionally, the box could provide a strengthening surface for rear connectors, if present.

Is there a good source for these?

Thanks for any ideas/leads.
Post Reply