2720 noisy VCA problem

Free-for-all discussion about PAiA products and the kinds of audio you produce with them.
Post Reply
patrickvf
Posts: 58
Joined: Wed Sep 25, 2013 10:31 pm
Hometown: University Place, WA
Favorite topic: Synths
Super Robot Smashing Puzzle Time!: 12

2720 noisy VCA problem

Post by patrickvf »

I finally got around replacing some modules in my working 2720 with those from the other one (the modules with the brown jacks). While the hum is mostly gone, and the signal is nice and strong (through the BPF at least), the VCA has some serious issues. There is a lot of noise and when patched to one of the LFOs it makes a kind of "thump-pa-thump" sound with nothing routed through it, and even then it seems to let only pass a signal at high CV levels and it's still distorted. While I understand that the cause could be failing components and bad solder joints, I'd first like to hear some opinions/suggestions before I start doctoring around on it. One thing that I noticed is that if I push capacitor C2 towards the op-amp, the noise increases and wise versa. Also, the noise level drops significantly (but doesn't disappear) when I physically touch the capacitor. There are also some very old style transistors on this thing (not the can ones but ones that look like cut in half. Any suggestions for a specific cause and quick fix of this problem? Which of the components would be most likely at fault?
User avatar
PAiA-Scott
Posts: 733
Joined: Sun Nov 09, 2008 2:49 pm

Re: 2720 noisy VCA problem

Post by PAiA-Scott »

Go through the procedure for testing and setting the trim, but also note the explanation about summing input control so there isn't too much which could cause distortion.

http://www.paia.com/talk/viewtopic.php?f=6&t=571

For the transistors, this topic covers the pin-outs for the various types we have included with the kits, matching them with the E(mitter), B(ase) and C(ollector) pcb points according to the silk-screened outline graphics.

http://www.paia.com/talk/viewtopic.php?f=7&t=200

Look for joints that didn't flow or may have bridged, verify all parts are installed as specified and confirm the +9 and +18 DC power supply voltages.
Scott Lee
scott@paia.com
Billb3
Posts: 61
Joined: Wed Jan 01, 2014 1:36 pm
Hometown: Toronto
Favorite topic: custom mods
Super Robot Smashing Puzzle Time!: 12
Location: Toronto

Re: 2720 noisy VCA problem

Post by Billb3 »

I posted an updated schematic a few posts down which might help a bit
Post Reply